The only thing they were of any assistance on was concerning the automation functions but I can't get it to work. > I have tried the program's help section, user's manual and 2 books on Sonar 5 but they have been of no help for any of these 3 problems. Unfortunately, that flow in X1 is entirely worth it, because trying to use SONAR 8.5 Producer.
#SONAR 8 PRODUCER EDITION MANUAL HOW TO#
I have experience using Logic Platinum 5 and I knew how to do it on that but things are more difficult in Sonar. It is immediately important to note that SONAR X1 is not actually different from this version, Cakewalk SONAR 8.5 producer edition, and therefore, it is especially important to note that this program simply flows differently than X1. How do you set up track automation for volume control using nodes? I went into the automation mode but no matter what, it would not allow any nodes to be placed. How do you change the Project End point? No matter what I tried, it would not change.ģ.
![sonar 8 producer edition manual sonar 8 producer edition manual](https://www.libble.eu/bestanden1/698816/bg5.png)
I know it is possible because I did it once but don't remember how I did it and it's difficult to figure out.Ģ. How do you assign an output to more than one channel without having to destroy the surround sound setup I have for the 5.1 surround sound? I am running PreSonus Firepods for output and want to assign a headphone amplifier output to channels 7 & 8 so I can get a stereo output and not just a 1 channel output. I purchased the program from Musician's Friend and they told me that they had online technical support but once again, I was totally ignored.ġ. I also tried e-mailing them but never got any reply.
![sonar 8 producer edition manual sonar 8 producer edition manual](https://i.ytimg.com/vi/Sw8p68sGxq0/hqdefault.jpg)
I tried contacting Cakewalk by phone and was put on hold for 1 1/2 hours and never got through. >I am hoping to get assistance with Sonar 6 Producer's Edition.